Shown below is a photo of the package of salmon on a cutting board. This is just over 1 lb. We like Wild Alaskan Salmon.

Cut the salmon into small slices for slightly crispy edges and a nice texture.

Place in a foil-lined pan and sprinkle with paprika and garlic powder.

Broil on high for about 10 minutes … cooking time will vary according to the thickness of the salmon. Folding the foil over to completely enclose the salmon and allowing to steam for about 5 minutes will help make it more tender and juicy.

Serve with green salad or sliced vegetables or brown rice. Shown below with sliced cucumbers and tomatoes with a little brown rice.

Shown below is a photo of all the ingredients. Starting in the upper right corner and moving counter-clockwise: crushed garlic, ground cumin, cayenne pepper, chili powder, onion, lime and dried pinto beans.

Start by cooking the pinto beans. Please see this post for complete instructions. After cooking the beans, use a masher to mash them while in the pot.

Chop the onions …

Place the chopped onions in a large skillet.

Measure out portions of the other ingredients and set them aside in dishes. Shown below (left to right): all the dry ingredients in the dish on the left (ground cumin, cayenne pepper, chili powder and salt), then crushed garlic in the middle dish followed by fresh squeezed lime juice in the last dish.

Sauté the chopped onions in water, gradually adding more water as necessary – about a tablespoon at a time – to keep the onions from sticking to the skillet or burning. After cooking for about 8 minutes, add the crushed garlic.

Continue to cook the vegetables for about 2 minutes more. Just infuse the flavors into the vegetables.

When the onions and garlic are cooked, add the mashed beans.

Use the masher or wooden spoon and continue to cook the vegetables and mashed beans together. After a minute or two, add the dry seasonings (ground cumin, cayenne pepper, chili powder and salt).

Continue to cook and stir the mashed beans with a masher or wooden spoon for another minute or two, then add the fresh squeezed lime juice.

Using the masher, thoroughly mix the fresh squeezed lime juice throughout the mashed beans. When everything is all mixed together, the refried beans will be done.

Fat Free Pinto Beans

Start with a medium sized cooking pot with lid. I like to cook 3 1/2 cups of dried beans at a time. Measure out the beans and spread them out on a clean, flat surface, then sort through them and discard any stones or shriveled beans.

Cover the beans with 1 to 2 inches of water (see photo below … it is hard to see the water line in the photo). Place the lid on the pot and set the beans in the refrigerator and allow to soak overnight.

The next day, most or all of the water will have been soaked up by the beans. If necessary, add more water just prior to cooking. Add enough water to just cover the beans.

Place the pot over a flame and bring water to a boil, then reduce to a very low flame. Allow to cook for 2 1/2 to 3 hours.

Shown below is a photo taken just after water begins to boil and just before reducing the flame. Stir occasionally, checking the water level periodically and adding more water as necessary to just cover the beans during cooking. It has been my experience that water needs to be added around the first 20 minutes after boiling.

During the last 30 to 45 minutes, there may be a tendency for the beans to stick to the pan, so be careful around this time. Stir the beans and make sure the flame is very low and that the water level covers the beans.

The beans should be fully cooked in no more than 3 hours. Once you have cooked the pinto beans, you can make them into refried beans, or you can allow to cool and place in a covered container in the refrigerator. You can also freeze some of them if you like, then place in the refrigerator after thawing.

Shown below is a shot of all the ingredients. Starting in the back row and going clockwise: onion, Tikka Masala sauce, salt, pepper and dried split peas. These are organic split peas, but you can make the recipe with conventional split peas.

Measure out the split peas and place into a pot. Rinse thoroughly. As you can see by the cloudy color of the water, you will have to rinse them about 8 to 10 times.

Pour the rinse water out through a strainer after each rinse.

Quarter the onion, then peel and chop it. Place 1/4 of the chopped onions (1/2 cup) into the pot with the split peas.

Cook the split peas and chopped onions for 1 hour. Cook them slow over a low flame. Stir occasionally to keep from sticking to the pan. If they start to stick to the pan, then lower the flame.

While the split peas are cooking, chop the cloves of garlic. Here I am using a chopper.

Add the remaining chopped onions, chopped garlic and Tikka Masala sauce to a pan. Add about 1/4 cup of water to the pan and start cooking the vegetables. Add more water if necessary to keep from burning the vegetables while they are cooking. Cook them for about 10 to 12 minutes.

Cook the vegetables until they are soft and light golden brown in color.

After the split peas have cooked for an hour, add the cooked onions plus 1/4 tsp of pepper to the soup. Add salt as needed for taste.

Cook for an additional 15 minutes to allow the flavors to blend thoroughly.

Serve hot. This is a delicious, healthy soup.

Add a cup of fresh, cooked brown rice to a bowl and mix in 1/4 tsp of curry powder and a dash of salt. This is very quick and easy. If you like curry dishes, you should like this.

Here’s how to cook brown rice in a rice cooker. Start by measuring out the amount of rice you want to cook. I will be making 3 cups in this example.

Rinse the rice thoroughly – several times – until the rinse water is clear.

Strain the rice after each rinse … I will usually rinse about 5 or 6 times.

After rinsing, add water. The cooker has marks on the sides of the cooking pot. I will add water up to the 3-cup mark.

Place the cooking pot in the cooker. Here it is just before closing the lid.

Set the cooker for cooking brown rice and push the button to start cooking. This model has a red LED indicating that the rice is cooking and a yellow LED for the rice to "keep warm". Just before the rice is done, the yellow LED will flash, indicating that it is almost finished cooking.

When the rice has finished cooking, this model will beep out loud to alert you. Open the lid and fluff the rice as soon as it is done to allow excess steam to escape. Close the lid back down to keep warm.

Fluff the rice and serve.

Start by adding water to a saucepan, then add a dash of salt.

Stir to dissolve the salt, then add the oats, stirring them as you add them. Turn on a high flame after adding the oats.

Stir, then bring the mixture to a boil. Turn down the flame and keep stirring to keep the bottom part from sticking to the pan. The oatmeal will be cooked when it has thickened and starch has formed. You can see the starch forming when the fiberous part of the oats break down.

I like to add a tablespoon of rice bran and a tablespoon of milled flaxseed plus a little Stevia extract for sweetening. Stevia is more healthy than sugar. Instead of adding the rice bran and flaxseed to the bowl, sometimes I will just add it to the cooked oatmeal in the pan.

After adding the cooked oatmeal to the bowl I will add toppings. One of my favorite topping combinations is shredded coconut and banana.

Another great topping combination is all natural apple butter (made without sugar) and ground cinnamon. I use about a tablespoon of apple butter. You can also sprinkle some chopped raw almonds or pecans or walnuts for a crunchy texture.

You can always serve it plain – without toppings…

Or you can simply add some fresh or frozen berries … here it is with some bluberries – one of my favorite toppings.

Shown below is a shot of all the ingredients: carrots, celery and onions, garlic cloves, bay leaves, thyme, salt and pepper.

Add water to a pot, then turn on the flame to bring water to a boil. While the water is heating, chop the vegetables. I am using a food processor to speed things up.

Shown below is a shot of the pot with the water before boiling.

When the water begins to boil, add the carcass and all the turkey bones to the water. I added a little meat from the neck in this example…

Add all the vegetables, the chopped garlic and bay leaves to the water, then add the thyme, salt and pepper. Bring everything to a boil, then lower the flame to a low boil and cover and allow to cook for a couple of hours.

After a couple of hours, check the soup and see how the meat is softening on the bones. Add more water if necessary to replace any that gets boiled away. I usually have to continue cooking for another hour.

After an hour or so, check the soup again. It will be done when the meat is falling off the bones.

Turn off the heat and pull the bones out of the soup with some kitchen tongs. Place them into a strainer over a plate. Pour the strained soup back into the pot, then separate all the meat from the bones and add it to the soup. At this point you can also skim off the fat that floats to the top of the soup.

Use a soup ladle and serve hot. Store excess in 2 qt Mason jars in the refrigerator for later.